General Information; Installation; Gas & Electrical Connection - Viking RDGSU2005B Installation Manual

General Information

Electrical Requirement
CAUTION
Normal grounded household current,
120 volts, 60 Hz, 15 amps, single phase.
BURN HAZARD
Electrical installation should comply with
The use of cabinets for storage above the national and local codes.
appliance may result in a potential burn
Air Supply and Ventilation
hazard. Combustible items may ignite,
metallic items may become hot and Means must be provided for any heavy-duty
cause burns. If a cabinet storage is to be cooking appliance to exhaust combustion
provided the risk can be reduced by waste product to the outside of the building.
installing a range hood that projects It is recommended that the cooktop be set
horizontally a minimum of 5" (12.7 cm) under a powered, vented exhaust hood, or
beyond the bottom of the cabinets. non-vented recirculating hood. Nothing
should obstruct the flow of combustion and
ventilation air.
WARNING
Gas Manifold Pressure
Natural gas – 5.0" W.C.P.
This appliance shall not be used for
LP/Propane – 10.0" W.C.P.
space heating. This information is based
on safety considerations.
Flexible Connections
If the unit is to be installed with flexible
• All openings in the wall behind the couplings and/or quick disconnect fittings,
appliance and in the floor under the the installer must use a flexible connector of
appliance shall be sealed. at least 1/2" I.D. (1.3 cm) NPT with suitable
strain reliefs and comply with ANSI Z21.41
• Keep appliance area clear and free from and Z21.69 standards.
combustible materials, gasoline, and other
flammable vapors.
• DO NOT obstruct the flow of combustion
and ventilation air.
• Disconnect the electrical supply to the
appliance before servicing.
When removing cooktop for cleaning and/or
service:
• Shut off gas at main supply
• Disconnect AC power supply
• Disconnect gas line to the inlet pipe.
• Lift appliance out of cabinet cutout.
14

Installation

1
Remove the grates and burner caps.
Gas & Electrical Connection
1
Note: Refer to
"Electrical & Gas
Requirements"
section for
proper
installation
information.
15
2
Turn the cooktop over and place into countertop
opening.