Advertisement
Fig. 4A
A
U
T
O
Setting
To set, press and release the desired function, and within 5 seconds
set the time
using the
+ and - buttons.
+ and - buttons.
The + and - buttons increase
speed depending on how long the button is pressed.
Setting the time
Press any two buttons
manual
set the desired time. This deletes any previously set programme. The
contacts are switched off and the AUTO symbol flashes.
Manual use
When
the manual button
is pressed
AUTO symbol switches off and the saucepan symbol lights up.
Manual operation can only be enabled after the automatic programme
is over it has been cancelled.
Automatic
function
Press the cooking time or end time button to switch automatically from
the manual to the automatic function.
Semi-automatic use
to set
cooking time
Press the cooking time button and set the desired time with + or -.
The AUTO and cooking time symbols light up continuously. The relay
switches on immediately. When the cooking end time
relay and cooking time symbol switch off, the
and the AUTO symbol flashes.
Semi-automatic use
to set
end time
Press the end time button. The time of day appears on the display.
Set the cooking end time with + button. The AUTO and cooking time
symbols light up continuously. The relay contacts switch on. When
the cooking end time
is
reached, the relay and the cooking time
symbol switch off. When the cooking time is finished, the AUTO
symbol flashes, the
acoustic signal sounds
the cooking time button switch off.
Automatic use
to set
cooking time and end time
Press the cooking time button and select the
time with + or - button. The AUTO and cooking time symbols light up
continuously.
The relay switches on.
When the
the next cooking end time
is shown
end time with + button. The relay and the cooking time symbol switch
off.
The symbol lights up again when the cooking start time
When the cooking time is finished, the AUTO symbol flashes, the
acoustic signal sounds and both
relay switch off.
Minutes
minder
Press the minute minder button and set the cooking time with + or -
button.
The bell symbol lights up when the minutes
When the set time is finished, the
symbol switches off.
Acoustic
signal
The
acoustic signal sounds
minutes
minder
function and it lasts for a
To stop it, push any one of the functions buttons.
Start programme and check
The programme starts 4 seconds after it has been set.
The programme can be
verified
corresponding button.
Minute
minder
Cooking time
Cooking end
Manual
Decrease
time
Increase
time
and
decrease the time
respectively the
at the same time, and + or - button to
the relay contacts switch on, the
is
reached, the
acoustic signal sounds
and both the relay and
duration
of the cooking
cooking end time button
is pressed
on the display. Set the cooking
is
reached.
the cooking time symbol and the
minder
is operating
acoustic signal sounds
and the bell
at the end of a programme or of the
maximum of
15 minutes.
at any time by pressing the
GB
Setting error
A setting error is made if the time of day on the clock falls within the
cooking start and end times.
To correct the setting error, change the cooking time or cooking end
time.
The relays switch off when a setting error is made.
Cancelling a setting
To cancel a setting, press the cooking time button and then press
the - button until 00 00 appears on the display.
A set programme will automatically cancel on completion.
CARE AND MAINTENANCE
Before cleaning the appliance,
unplug the appliance or disconnect power at the main circuit
breaker of the electrical system.
Do not
clean appliance
Do not use steam cleaners to clean the oven.
IMPORTANT
Periodically check the external gas connection hole and replace
it when it shows any sign of wear. Do not
attempt to repair the gas hose.
ENAMELLED SURFACES
Clean with a damp sponge using soap and water.
Grease can be easily removed using hot water or a specific cleansing
agent for enamelled surfaces. Do not use abrasive cleansers.
Do not leave any acid or alkaline substances (lemon juice, vinegar,
salt, etc.) on the enamel.
Clean the parts in stainless steel with specific cleansers for stainless
steel surfaces.
These detergents must be applied using a soft cloth.
GRIDS AND BURNERS
To clean the
cooktop
burners,
them for
approximately
10 minutes in hot water with a little detergent.
After
cleaning
and
washing
Make sure that burner holes
Clean the burners once a week or more frequently if necessary.
MAKE SURE YOU HAVE ASSEMBLED THE BURNERS
CORRECTLY.
OVEN
Clean
enamelled
parts with a damp sponge using soap and water.
Grease can be easily removed using hot water or a specific cleansing
agent for enamelled surfaces.
Do not use abrasive cleansers.
Install shelves by locating them in the horizontal guide rails
on the oven walls.
INSTRUCTIONS
OVERALL DIMENSIONS
895
WARNINGS
Do not use the oven door handle to move the appliance,
to remove it from the packaging.
The appliance is in class 1 or class 2 subclass 1.
IMPORTANT:
Any adjacent
temperatures (min. 90°C).
If the appliance is to be installed near units, leave the minimum gaps
specified in the table below.
5
turn off the mains
surfaces when still hot.
under any cincumstances
remove by
pulling upwards and soak
them,
dry
them carefully.
are not
clogged.
FOR
THE USER
600
furniture must be able to withstand high
gas tap and
for example
Advertisement
