Installing The Motor Pulley; Installing The Control Box - Brother RH-981A Instruction Manual

3. INSTALLATION

3-3. Installing the motor pulley

3-4. Installing the control box

7
1. Place the motor pulley (1) onto the shaft of the
3126Q
motor (2) so that the key grooves are aligned, and
then tighten the set screws (3) so that the center of
the V groove in the motor pulley (1) is aligned as
closely as possible with the center of the belt hole in
the power table.
2. Install the motor rear cover support (4) with the two
flat washers (5) and the two screws (6).
Note: Check that the motor rear cover support (4)
does not touch the motor pulley (1) or the
edge of the motor.
3127Q
1. Insert the four nuts (1) into the work table.
2. Open the front and rear covers of the control box
(2).
3. Align the control box (2) with the nuts (1), and then
install it with the four flat washers (3), spring
washers (4) and bolts (5).
Note: Be careful not to drop any small parts such
as washers onto the circuit board when
installing the bolts.
3128Q
RH-981A