Installing The Motor; Installing The Motor Pulley - Brother LK3-B438E MKII Instruction Manual

3. INSTALLATION

3-2 . Installing the motor

q
u
1 m m

3-3 . Installing the motor pulley

q
w
7
Install the motor u to the work table with the four ac-
cessory bolts q, cushions w, cushion collars e, flat
q
washers r, spring washers t and nuts y.
At that time, fix by setting bolts q a little to the right
of oval hole on motor.
NOTE:
w
e
r
t
y
Table
e
Place the motor pulley q onto the shaft of the motor
w so that the key groove is aligned, and then tighten
the set screw e so that the center of the V groove in
the motor pulley q is aligned as closely as possible
with the center of the belt hole in the power table.
e
LK3-B438E Mark II
Tighten the nuts y so that the clearance between the table
and the cushion collars e is approximately 1 mm.