HP StorageWorks 600 - Modular Disk System User Manual page 19

Be sure the I/O modules or I/O blanks are fully seated and their handles are in the locked position.
2.
The hard drive drawer does not open if I/O modules or I/O blanks are not fully seated with their
handles in the locked position.
TIP HAZARD! To reduce the risk of personal injury or damage to the equipment,
WARNING:
do not extend the hard drive drawers beyond the supporting surface when the unit is not
installed in a rack.
WARNING: To reduce the risk of personal injury or damage to the equipment, ensure that
only one hard drive drawer is extended at a time.
To reduce the risk of personal injury or damage to the equipment, you must
WARNING:
adequately support the chassis during installation and removal. It is not secured to the rack
frame or mounted on rails.
Extend the hard drive drawer.
3.
WARNING: Pinch hazard—Keep hands out of front and rear of chassis when closing hard
drive drawers.
CAUTION: To prevent improper cooling and thermal damage, do not operate the MDS600
for an extended period of time with the drawer open.
CAUTION: To prevent improper cooling and thermal damage, do not operate the MDS600
unless all bays are populated with either a component or a blank.
Setup 19