Lenovo ThinkPad Edge 11 Hardware Maintenance Manual page 85

Table 24. Removal steps of DC-in cable and base cover assembly
Applying labels to the base cover
If the Windows Certificate of Authentication label (COA)
old part with the label attached to the customer, or provide a letter to the customer stating what the label
was originally on the system and what the label part number, serial number, and product key were.
The new base cover FRU is shipped with a kit containing labels of several kinds. When you replace the
base cover, you need to apply the following labels:
2
SIM information label under door
3
Information label under door
5
Certified label under battery
Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.
4
Ethernet label
For some models, you also need to apply one or two FCC labels. Check the old base cover; if it has one or
two FCC labels, find duplicates of them in the label kit and apply them to the new base cover.
For the location of each label, refer to the following figure:
1
2
3
1 is attached to a part that is replaced, return the
.
Chapter 8 Removing and replacing a FRU
79