Virtual Connect Firmware Upgrade Using Hp Sum Fails If Vc Reports An Invalid Or Bad Health State - HP ProLiant BL420c User Manual

1 1. Restart HP SUM.
Performing these steps allows HP SUM to function, although after a period of time (ranging
from minutes to hours), McAfee disables HP SUM access.
Virtual Connect firmware upgrade using HP SUM fails if VC reports an
invalid or bad health state
Virtual Connect firmware can be upgraded using HP SUM only if the health state of the VC is in
a good state. If the health state is invalid or bad, HP SUM does not upgrade the VC firmware.
If a VC upgrade is attempted in an invalid or bad health state, the HP SUM installation fails or
causes an outage. The details of the failure can be viewed in the Installation Log by clicking the
View Installation log link in the Additional section.
Some of the VCSU Health Status bad states are:
VC health is invalid or bad
VC module is not redundant
VC is not part of a domain
The user wants to select the order of deployment
The user wants to back up the configuration before flashing the VC
firmware
Cannot authenticate to OA (bad OA IP or User/Password) or to VCM
(bad VCM IP or User/Password)
Could not retrieve a list of modules in the domain or the module is
empty
For any modules, the power is not ON, the hardware health is not
OK, cannot connect to module IP address, or the module role is
Unknown
OA version is version 3.00 or earlier, or the VLAN feature is enabled
and VC modules are on a different VLAN ID than OA
VCM Domain checkpoint is not valid
VCM Module adjacent to the Primary VCM is not compatible with the
Primary VCM

Virtual Connect firmware upgrade using HP SUM fails if VC reports an invalid or bad health state

39