Setting Clock At Power Up - Electrolux 30" FREE-STANDING GAS WAVE-TOUCHTM RANGE 316471110 Use And Care Manual

Setting clock at power up

You will be prompted to enter the time of day in the
event of a power failure or when you first provide
electric power to your appliance.
• When your appliance is first powered up, 12:00
will flash in the display.
• Enter the time of day using the numeric key
pads and press START to set.
If an invalid time of day is entered, the control will
triple beep. Re-enter a valid time of day and
press START. If CANCEL is pressed your clock
will start with the time set for 12:00.
Select the user pref key to modify the time of day
during other situations such as day light savings.
Wave-Touch™ display modes
Sleep mode
Your control will remain in a sleep mode -Fig.1-
when not in use. Only the clock will display during
this mode. You will need to wake the contr o l to
begin an oven feature. The cooktop is available in
sleep or awake mode.
Awake mode
To awake the contr ol -Fig. 2- touch within the
display panel. If the control panel is not touched
again within 2 minutes, the control will return to the
sleep mode. To start cooking you must select
either the upper or lower oven. User preferences
will be available during this mode as well as
timers, oven light and the control lock.
Sleep mode
Awake mode
Getting Started
Timers
The two timers provided with the oven control
serve as extra reminders in the kitchen. When a
timer reaches less than 1 minute the display will
start to count down in seconds. When the time
runs out the active timer will beep, " 00:00" will
display and the timer key will flash.
The following time settings apply to the timers:
• Min. time: 1 minute
• Max. time: 11 hours 59 minutes
See example below to set the timer for 5 minutes:
Example
Step
1. Press TIMER
2. Enter 5 minutes
3. Press TIMER
To cancel after setting the timer , press the TIMER
key again.
NOTE
The timer(s) will not affect the cooking process.
11
Press
Fig.1
Fig.2