Installing And Replacing Motherboard Components; Before You Begin - Intel SE440BX - Desktop Board Motherboard Product Manual

2 Installing and Replacing Motherboard
Components
This chapter describes the following:
How to install and remove the motherboard
How to install a processor
How to prepare the motherboard for a boxed Pentium II processor
How to install and remove memory
How to replace the battery
How to use the configuration jumper to set processor speed and clear passwords

Before You Begin

CAUTION
Before you install this motherboard in a chassis, see Appendix B for regulatory requirements and
precautions.
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
Use an antistatic wrist strap and a conductive foam pad when working on the motherboard.
WARNINGS
The procedures in this chapter assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications links,
networks, or modems before performing any of the procedures described in this chapter.
Failure to disconnect power, telecommunications links, networks, or modems before you open
the computer or perform any procedures can result in personal injury or equipment damage.
Some circuitry on the motherboard can continue to operate even though the front panel power
button is off.
CAUTION
Electrostatic discharge (ESD) can damage components. Perform the procedures described in this
chapter only at an ESD workstation. If such a station is not available, you can provide some ESD
protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer
chassis.
19