Usb - Intel DH61AG Specification

1.6.3

USB

The board supports up to ten USB2.0 ports and two USB 3.0 ports.
The Intel H61 Express Chipset provides the USB controller for the USB 2.0 ports. The
two USB 3.0 ports are provided by the NEC D720200 controller. The port
arrangement is as follows:
• Two USB 3.0 ports are implemented through two back panel connectors (blue).
• Two USB 2.0 high-current/fast charging ports are implemented through two back
panel connectors (yellow).
• Four USB 2.0 ports are implemented through two dual-port internal headers
(black).
• One USB 2.0 port is implemented through a single-port internal header (black).
• One USB 2.0 port is implemented in the PCI Express Half-Mini Card slot.
• Two USB 2.0 ports are implemented in the PCI Express Full-Mini Card slot.
All ten USB 2.0 ports are high-speed, full-speed, and low-speed capable.
USB 3.0 ports are SuperSpeed capable as well as backwards compatible with USB 2.0
high-speed, full-speed, and low-speed modes. USB 2.0 functionality will be enabled
on these ports for basic BIOS setup/update operation, however the USB 3.0 driver
must be installed for the operating system to use them.
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use a
shielded cable that meets the requirements for full-speed devices.
For information about
The location of the USB connectors on the back panel
The location of the front panel USB headers
To download...
The USB 3.0 driver
Visit this World Wide Web site:
http://downloadcenter.intel.com
Product Description
Refer to
Figure 12, page 48
Figure 13, page 49
29