Serial Ports; Parallel Port; Diskette Drive Controller; Keyboard And Mouse Interface - Intel D915GUX Specification

Intel Desktop Board D915GUX/D915GHA Technical Product Specification
•
Intelligent power management, including a programmable wake-up event interface
•
PCI Conventional bus power management support
The BIOS Setup program provides configuration options for the I/O controller.

1.8.1 Serial Ports

The Desktop Board can support up to two serial port connectors. Serial port A is located on the
back panel. Serial port B (optional) is accessible using a connector on the component side of
board. The serial ports support data transfers at speeds up to 115.2 kbits/sec with BIOS support.
For information about
The location of the serial port A connector
The location of the serial port B connector
The signal names of the serial port B connector

1.8.2 Parallel Port

The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup
program to set the parallel port mode.
For information about
The location of the parallel port connector

1.8.3 Diskette Drive Controller

The I/O controller supports one diskette drive. Use the BIOS Setup program to configure the
diskette drive interface.
For information about
The location of the diskette drive connector

1.8.4 Keyboard and Mouse Interface

PS/2 keyboard and mouse connectors are located on the back panel.

NOTE
The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top
PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is
connected or disconnected.
For information about
The location of the keyboard and mouse connectors
28
Refer to
Figure 16, page 56
Figure 17, page 58
Table 23, page 61
Refer to
Figure 16, page 56
Refer to
Figure 17, page 58
Refer to
Figure 16, page 56