Table of Contents
Advertisement
Table 27. Removal steps of VGA thermal device/fan (continued)
Table 28. Installation of the VGA thermal device/fan
When installing:
v Before you attach the fan assembly to the computer, apply thermal grease, at an
amount of 0.2 grams, on the part marked b as in the following figure. Either
too much or too less application of grease can cause a thermal problem due to
imperfect contact with a component. For the new VGA thermal device/fan, you
need to peel the thin films off from the rubbers marked a .
v Make sure that the fan connector is attached firmly.
7
6
a
b
a
Removing and replacing a FRU
119
Advertisement
Table of Contents
