Onboard Computer; Timer Programming; End Of Programme - Bosch SMS69L22GB Operating Instructions Manual

en Operating the appliance

Onboard computer

You can switch the onboard computer
(additional programme information) off
or on. Proceed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )"
until : ... is indicated on the digital
display 8.
4. Release both buttons.
The LED for button # flashes
and the digital display 8 displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display 8.
To change the setting:
1. By pressing the 3 button, you can
switch the on board computer
(additional programme
information) off :
2. Press START button )".
The set value is saved.
3. Close the door.

Timer programming

You can delay the start of the
programme in 1 hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press the button ` + until
flaching in the timer programming
display X.
4. Press + or – button until the `
displayed time corresponds with your
requirements.
22
.
or on : .
is
5. Press START button )", timer
programming is activated.
6. To delete timer programming `,
press the + or – button until
indicated on the digital display X.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.

End of programme

The programme ends when the value
appears on the digital display 8
:
and Finished appears in the display
window )2.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
To change the setting,
1. Press programme button 3. Each
time the button is pressed, the set
value increases by one level; when
the value of :
the display jumps back to :
2. Press START button )", the set
value is saved.
3. Close the door.
is
.
is
has been reached,
(off).