Removing The Pedestal - HP D7171A - NetServer - LPr Installation Manual

Chapter 2

Removing the Pedestal

The pedestal version of the HP NetServer LC 2000 mounts to an anti-tip
pedestal, which must be removed to mount the server in a rack.
NOTE
The front bezel is shown removed, but the bezel may remain
on the chassis while removing the pedestal.
1. Disconnect all cables connected to the rear of the NetServer that would
limit its rotation before continuing.
2. Turn the NetServer over onto its top and pull up on the two tabs as shown
in Figure 2-3.
3. Slide the pedestal to the rear of the NetServer as shown in Figure 2-3.
Prepare the HP NetServer for Rack-Mounting
Figure 2-3. Removing the Pedestal
9