Download Print this page

Section 3. Os/2 Cd-Rom Installation Procedures - HP D7171A - NetServer - LPr Software Install Manual

Ibm os/2 installation guide
Hide thumbs Also See for D7171A - NetServer - LPr:

Advertisement

Use this procedure to create a "Drivers/Utilities" diskette using the "Diskette Library" on the
Navigator CDROM:
1. Boot Navigator
2. Click. NetServer Utilities
3. Click, More Utilities
4. Click, Diskette Libraries
5. Select "NOS Drivers - OS/2 Warp Family" and then click execute (see the following
note).
NOTE: Only "OS/2 Warp Family" is supported on the E40. There is no
OS/2 2.11 support for the E40.
6. Select "COPY ALL" to create the two driver diskettes. If you wish to make only one
diskette just select the one you need from the list provided on the screen. You can
create the video driver by selecting video from the list provided on the screen.
7. Insert Diskette when prompted and follow the instructions.
8. If needed, create the video driver by following the same procedure.
9. Click exit when done.
10. Click Yes, to reboot the system. Continue to Task 5.
Task 5) Copy the required drivers (which are identified in Task3) from "HP Diskette #1: SCSI -
DAC drivers and utility" to the "Work Diskette 1".
Task 6) Edit Config.sys file in "Work Diskette 1" to include the drivers entry which are added in
Task 5 and delete drivers entry which are removed in Task 2.
Task 7) Include "set copyfromfloppy=1" as the first line in config.sys in "Work Diskette 1" to
allow the installation process to copy drivers from floppy than from OS/2 Installation CDROM.

Section 3. OS/2 CD-ROM Installation Procedures

Be sure to check the considerations and tips listed above before starting the installation process.
Also, complete the planning table listed in "Consideration 1".
Note that this document was written using the Adaptec driver AIC7870.ADD. However if your
system uses a different SCSI driver, just use your driver name in place of the one listed in this
document. For example, since the HP NetServer LC uses the AIC7770.ADD driver, you must
replace the AIC7870.ADD driver entry with AIC7770.ADD everywhere in this document.
On the following pages you will find separate procedures for:
16

Advertisement

loading