Verifying The Replica Installation; Installing Tapeassure For Hp T4 Tape Drive Verification And Diagnostics - HP D6030A - NetServer - E50 Getting Started

Chapter 3
order to ensure correct operation of all software. Then proceed with the
installation instructions below.
Installing Replica for use with a NetWare 3.12 or IntranetWare Server
1. From an administration PC running Windows 95, log in to the server as
supervisor (or as a user with equivalent privileges).
2. Map a drive letter to the HP NetServer's SYS volume.
3. Insert the Stac Replica Backup HP SureStore Tape Edition CD-ROM in
the administration PC's CD-ROM drive.
4. Execute the SETUP.EXE module stored in the \stac directory.
5. Once the Setup utility is running, follow the on-screen instructions for
completing the installation.
6. Update STARTUP.NCF through NetWare's INSTALL utility. Make sure
it contains the line:
SET RESERVED BUFFERS BELOW 16 MEG=200
7. Enable support for HP OpenView or HP TopTools. Add the following line
to AUTOEXEC.NCF just ahead of "LOAD REPLICA":
LOAD STACSDI -snmp
8. When the installation is complete, restart the server to load Replica.
When the HP NetServer restarts, Replica is ready for use.

Verifying the Replica Installation

If Replica is successfully installed on your HP NetServer, three program shortcuts
appear as icons on your desktop and the Replica application is available through
the Start menu, under the Replica Program Group. For more information on the
Replica shortcut icons, see the section, "Using Replica Shortcuts," in Chapter 4.
Installing TapeAssure for HP T4 Tape Drive
Verification and Diagnostics
HP provides an easy-to-use software utility, TapeAssure, that lets you confirm
that the HP SureStore T4 tape drive is properly installed and set up for operation.
You can also use the utility to perform diagnostics on your tape drive. In
addition, TapeAssure provides tips for resolving any tape drive problems.
10
Installing Replica