HP D6030A - NetServer - E50 Getting Started page 12

Chapter 3
If your HP NetServer is running Windows NT 3.51:
To install Replica on an HP NetServer running Windows NT 3.51, you must first
install the T20 device driver.
Adding a T20 Device Driver
To add the T20 device driver:
1. Reboot the HP NetServer from the installed operating system.
2. Open the Main folder and double-click the Windows NT Setup icon.
3. Choose Add/Remove Tape Devices from the Options pull-down menu.
4. Click the Add button.
The Select Tape Device Options screen displays a list of available devices.
5. Choose Other from the list and press Enter.
The Insert Disk window appears, prompting you for the disk containing
the required driver.
6. Insert the appropriate drivers disk into drive A, then enter the pathname
A:\T20\NT351 in the entry field, and click OK.
The Select OEM Option screen appears, listing the driver(s) provided on
the disk.
7. From the list, choose the HP Colorado T20 driver, and click OK.
8. Click the Install button to begin the driver installation.
A dialog box appears, asking you to confirm the source directory of
the driver.
9. Click the Continue button.
10. When the installation is complete, click Close to exit Tape Device Setup,
then close the Setup utility.
11. Shut down Windows NT and reboot the HP NetServer.
Installing Replica on Windows NT 3.51
After you have installed the T20 driver on your Windows NT 3.51 system, you
can install Replica.
To install the Replica software:
1. Insert the HP SureStore Tape CD-ROM in the HP NetServer CD-ROM
drive.
8
Installing Replica