Select Computer System Manually - Sanyo XF42 - PLC XGA LCD Projector Owner's Manual

Instruction manual, plc-xf42

Hide thumbs Also See for XF42 - PLC XGA LCD Projector:

Brochure (1 page)

Table Of Contents

Table of Contents

WHEN SELECT INPUT 2 (5 BNC INPUT JACKS )

When connect a computer output [5 BNC Type (Red, Green, Blue,

Horiz. Sync and Vert. Sync.)] from a computer to R/Pr, G/Y, B/Pb, H/HV

and V jacks.

Press MENU button and ON-SCREEN MENU will appear. Press

POINT LEFT/RIGHT button to move a red frame pointer to

INPUT Menu icon.

Press POINT DOWN button to move a red arrow pointer to Input

2 and then press SELECT button. Source Select Menu will

appear.

Move a pointer to "RGB", and then press SELECT button.

This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA, SXGA, WXGA or UXGA

(refer to "COMPATIBLE COMPUTER SPECIFICATIONS" on page 51-52). When selecting Computer, this projector

automatically tunes to incoming signal and projects proper image without any special setting. (Some computers need setting

manually.)

Note : Projector may display one of following messages.

When projector cannot recognize connected signal as PC

Auto

system provided in this projector, Auto PC Adjustment

function operates to adjust projector and message "Auto"

is displayed on SYSTEM Menu icon. (Refer to P28.)

When image is not provided properly, manual adjustment

is required. (Refer to P29 and 30.)

There is no signal input from computer. Make sure

––––

connection of computer and a projector is set correctly.

(Refer to TROUBLESHOOTING on page 47.)

This projector automatically selects PC system among those provided

in this projector and PC system can be also selected manually.

Press MENU button and ON-SCREEN MENU will appear. Press

POINT LEFT/RIGHT buttons to move a red frame pointer to PC

SYSTEM Menu icon.

Press POINT DOWN button to move a red arrow pointer to

system that you want to set, and then press SELECT button.

AUTOMATIC MULTI-SCAN SYSTEM