Remote Control Batteries Installation - Sanyo XF42 - PLC XGA LCD Projector Owner's Manual

Instruction manual, plc-xf42
Hide thumbs Also See for XF42 - PLC XGA LCD Projector:
Table of Contents

Advertisement

BEFORE OPERATION
Remove battery
1
compartment lid.
To insure safe operation, please observe following precautions :
● Use (2) AA or LR6 type alkaline batteries.
● Replace two batteries at same time.
● Do not use a new battery with an used battery.
● Avoid contact with water or liquid.
● Do not expose Remote Control Unit to moisture, or heat.
● Do not drop Remote Control Unit.
● If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
● Danger of explosion if battery is incorrectly replaced.
● Dispose of used batteries according to batteries manufacturers instructions and local rules.
Operating Range
Point Remote Control Unit toward
projector (Infrared Remote Receiver)
whenever pressing any button.
Maximum operating range for Remote
Control Unit is about 16.4' (5m) and
60° in front and rear of a projector.
20

REMOTE CONTROL BATTERIES INSTALLATION

Slide batteries into
2
compartment.
Pull up lid and
remove it.
16.4'
(5 m)
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
60°
16.4'
(5 m)
60°
Replace compartment lid.
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tur-72sdtur-60sdtur-48sdtur-28sd

Table of Contents