Telnet Commands For Configuration 1; Configuration 2: Two Fabric Assist Mode Zones In A Fabric - HP StorageWorks 2/16 - SAN Switch User Manual

Using QuickLoop Fabric Assist Mode
In the example shown in Figure 2, a fabric is formed from four switches, SAN
Switch1 through SAN Switch4. This Fabric Assist zone is named FaZone0 in
which a private host can access public and private target devices. Upon execution
of the telnet command shown in the following section is executed:

Telnet Commands for Configuration 1

1. Log onto the shell admin account on any switch in the fabric. The following
2. Issue the command:
3. Create the zone as part of or added to a configuration. For example:
The Fabric Assist zone FaZone01 is now part of the effective configuration.

Configuration 2: Two Fabric Assist Mode Zones in a Fabric

Figure 3 shows a second Fabric Assist mode zone created in a the same fabric as
Configuration 1.
For the details of setting up this example configuration using telnet commands,
refer to Telnet Commands for Configuration 2 on page on 42.
40
Private host K, connected to port (4,4), is zoned with the private targets c, h, j,
k, m, n and q, and the public targets d, e and r.
The port numbers for the private targets are (1,15), (3,10), (3,15), and (4,14).
The port numbers for the public targets are (2,1) and (4,1).
prompt will be displayed:
SilkW04:admin>
The switch listed in the prompt varies with particular switches.
Note:
fazoneCreate "FaZone01", "1,15; 3,10; 3,15; 4,14; H{4,4}; 2,1; 4,1"
cfgCreate "USA" "FaZone01"
cfgSave
Updating flash...
cfgEnable "USA"
zone "FaZone01" is in effect
Quickloop Fabric Assist User Guide