Port Side Of The Switch; Nonport Side Of The Switch; Hp B-Series Fabric Os Native And Ag Modes - HP SN6000B Hardware Reference Manual

Port side of the switch

Figure 1 (page 8)
Figure 1 Port side of the SN6000B 16Gb FC Switch
1. System status LED
2. Management Ethernet port with LEDs
3. USB port
4. FC ports (0-3)
5. FC ports (40-43)
NOTE: The two LEDs on the serial console port are nonfunctional.

Nonport side of the switch

Figure 2 (page 8)
power supply and fan assemblies (each including an AC power receptacle and AC power switch).
Figure 2 Nonport side of the SN6000B 16Gb FC Switch
1. Power supply/fan assembly #2

HP B-series Fabric OS Native and AG modes

The switch can function in either HP B-series Fabric OS Native mode or AG mode. The switch is
shipped in Native mode by default.
You can enable AG mode using HP B-series Fabric OS commands or Web Tools.
All POD licenses must be installed before you enable AG mode.
When you enable AG mode, you can use the default F_Port-to-N_Port mappings or change
this mapping using the CLI or Web Tools, after you configure an IP address as described in
"Setting the IP address" (page
8 HP SN6000B 16Gb FC Switch
shows the port side of the SN6000B 16Gb FC Switch.
shows the nonport side of the SN6000B 16Gb FC Switch, which contains two
21).
6. FC ports (44-47)
7. FC ports (4-7)
8. Switch ID pull-out tab
9. Serial console port
10. System power LED
2. Power supply/fan assembly #1