Pswp-1004; Pswp-1005; Pswp-1006; Pswp-1007 - Brocade Communications Systems SN3000B Reference

85

PSWP-1004

PSWP-1004
Message
<timestamp>, [PSWP-1004], <sequence-number>,, INFO, <system-name>, Blade Swap
complete for slots <slot number corresponding to the source blade> and <slot
number corresponding to the destination blade>.
Probable Cause Indicates that the bladeSwap command has been issued.
Recommended No action is required.
Action
Severity INFO

PSWP-1005

Message
<timestamp>, [PSWP-1005, <sequence-number>,, WARNING, <system-name>, Blade Swap
undo failed with error code <error code from undoBladeSwap>.
Probable Cause Indicates that the bladeSwap undo command has failed.
Recommended Use the portSwapShow command to display a list of currently swapped ports. Then use the
Action portSwap command to acheive the desired result.
Severity WARNING

PSWP-1006

Message
<timestamp>, [PSWP-1006, <sequence-number>,, WARNING, <system-name>, Blade Swap
failed on configInit with error code <error code from configInit> in switch number
<current switch number>.
Probable Cause Indicates that the bladeSwap command has failed to access the configuration data.
Recommended Retry the command. If the failure persists, contact your support representative.
Action
Severity WARNING

PSWP-1007

Message
<timestamp>, [PSWP-1007, <sequence-number>,, WARNING, <system-name>, Blade Swap
failed on fabosInit with error code <error code from fabosInit.>in switch number
<current switch number>.
Probable Cause Indicates that the bladeSwap command has failed to access the switch context.
Recommended Retry the command. If the failure persists, contact your support representative.
Action
Severity WARNING
558 Fabric OS Message Reference
53-1002448-01