Backing Up The Program Before Migration; Pre-Upgrade Procedure; Deleting The User Svc; Removing The Concatenation Of The Cataloged Procedures Library - HP StorageWorks P9000 Software Installation Manual

If you change the dataset name when backing up the configuration files, make sure that you change
the prefix only.
The configuration files contain the copy group ID, DAD ID, route list ID, and path set ID. Therefore,
if you change the dataset name, the consistency between the files is lost, and then Business Continuity
Manager might become inoperable.
For details about configuration files, see the HP StorageWorks P9000 for Business Continuity
Manager Software Reference Guide.

Backing Up the Program Before Migration

Before migration, acquire a backup of the dataset where Business Continuity Manager will be
installed.

Pre-Upgrade Procedure

Deleting the User SVC

If you upgrade Business Continuity Manager versions earlier than 5.1 to Business Continuity
Manager 5.1 or later, you must delete the user SVC before you install the new version of Business
Continuity Manager.
If the user SVC was registered by using the YKALCSVC command, you can use the YKALCSVC
command to delete the user SVC.
If the user SVC was registered by using the IEASVCxx parmlib member, you cannot use the
YKALCSVC command to delete the user SVC. In this case, perform the procedure below.
To delete a user SVC that was registered by using the IEASVCxx parmlib member:
1. Disable (comment out) the SYMDEF statement containing the &YKSVCNO system symbol in the
IEASYMxx parmlib member.
/* SYMDEF(&YKSVCNO='SVC-number') */
2. Disable (comment out) the SVCPARM statement containing the JYUASVC module in the
IEASYMxx parmlib member.
/* SVCPARM
3. Perform re-IPL with the CLPA parameter specified.
For details on steps 1 and 2, see the MVS Initialization and Tuning Reference.

Removing the Concatenation of the Cataloged Procedures Library

Remove the dataset concatenation of the following library:
DD Name
IEFPDSI
If you copied the HPQYPRCT library members to a user PROCLIB, delete the copied members.

Removing the Concatenation of the REXX Exec Library and the Libraries Used by ISPF Interface

Remove the dataset concatenation of the following libraries:
DD Name
SYSEXEC
ISPPLIB
48 Installing Business Continuity Manager
SVC-number,REPLACE,TYPE(3),EPNAME(JYUASVC) */
Library Name
Cataloged procedures library HPQYPRCT
Library Name
REXX Exec library
Panel library HPQYPNLT