Replacing The Sas Switch; Replacing A Sas Cable - HP P4000 Maintenance Manual

Replacing the SAS switch

This section provides instructions for removing and replacing the SAS switch in the HP P4800 G2
solution.
CAUTION:
blades using the procedures to shut down the management group in the CMC OnlineHelp or HP
P4000 SAN Solution User Guide.
IMPORTANT:
on the remaining switch. Before resetting a switch, verify that all storage is accessible by the
remaining data path. Replacing both SAS switches at one time disconnects the storage and could
compromise data integrity.
If a SAS switch fails, storage access continues through the remaining SAS switch. This causes
storage access to set a preference to all LUNs in the remaining data path. This preference remains
in place until the controllers in the blade enclosure are power cycled, or the remaining path becomes
unavailable.
CAUTION:
may damage the I/O module.
To replace the SAS switch:
1. Remove the power cable.
2. Disconnect the SAS cables, noting which cable goes to which port.
3. Remove the switch.
4. Install the replacement switch.
5. Attach the power cable.
6. Update the switch firmware.
a. Open the HP Virtual SAS Manager.
b. Select Force VSM Active.
This selection copies the zone and firmware information from the active switch to the passive,
replacement switch. The replacement switch then becomes the active switch.
7. Reconnect the SAS cables to their original locations, see
(page 32).
NOTE: Do not attach the SAS cables to the replacement switch until the firmware update is
complete.
Wait at least 60 seconds before removing another SAS switch.
The SAS switch should now provide a redundant access path to storage. Storage controllers will
distribute I/O evenly over the switches upon restart.

Replacing a SAS cable

CAUTION:
1. Before disconnecting a SAS cable, power down the HP P4460sb G2 storage blades using
the procedures to shut down the management group in the CMC OnlineHelp or HP P4000
SAN Solution User Guide.
2. Manually power off the disk enclosure.
3. Replace the SAS cable.
26 Removing and replacing the HP P4800 G2 solution components
Before replacing the SAS switch, be sure to power down the HP P4460sb G2 storage
Replace the SAS switches one at a time. When you remove a switch, I/O continues
Power down the disk enclosure before disconnecting a SAS cable. Failing to do so
Failing to follow these steps in this order may damage the I/O module.
"HP P4800 G2 solution cabling"