Dell Vostro 260 Owner's Manual page 58

Error Messages
DRIVE NOT READY
ERROR READING PCMCIA CARD
EXTENDED MEMORY SIZE HAS CHANGED The amount of memory recorded in non-
THE FILE BEING COPIED IS TOO LARGE
FOR THE DESTINATION DRIVE
A FILENAME CANNOT CONTAIN ANY OF
THE FOLLOWING CHARACTERS: \ / : * ? " <
> | -
GATE A20 FAILURE
GENERAL FAILURE
HARD-DISK DRIVE CONFIGURATION
ERROR
HARD-DISK DRIVE CONTROLLER FAILURE
0
58
Description
The operation requires a hard drive in the
bay before it can continue. Install a hard
drive in the hard drive bay.
The computer cannot identify the
ExpressCard. Reinsert the card or try
another card.
volatile memory (NVRAM) does not match
the memory installed in the computer.
Restart the computer. If the error appears
contact Dell .
again,
The file that you are trying to copy is too
large to fit on the disk, or the disk is full.
Try copying the file to a different disk or
use a larger capacity disk.
Do not use these characters in filenames.
A memory module may be loose. Reinstall
the memory modules and, if necessary,
replace them.
The operating system is unable to carry
out the command. The message is usually
followed by specific information. For
example, Printer out of paper. Take the
appropriate action.
The computer cannot identify the drive
type. Shut down the computer, remove the
hard drive, and boot the computer from a
optical drive. Then, shut down the
computer, reinstall the hard drive, and
restart the computer. Run the Hard Disk
Drive tests in the Dell Diagnostics.
The hard drive does not respond to
commands from the computer. Shut down
the computer, remove the hard drive, and