Creating A Raid 0 Set (Striped) - Asus P5Q3 - Motherboard - ATX User Manual

Creating a RAID 0 set (striped)

To create a RAID 0 set:
1. From the utility main menu, select 1. Create RAID Volume and press
<Enter>. The following screen appears.
Intel(R) Matrix Storage Manager option ROM v8.0.0.1027 ICH10R wRAID5
[↑↓]-Change
2. Enter a name for the RAID 0 set and press <Enter>.
3. When the RAID Level item is highlighted, press the up/down arrow key to
select RAID 0(Stripe), and then press <Enter>.
4. When the Disks item is highlighted, press <Enter> to select the hard disk
drives to configure as RAID. The following screen appears.
5. Use the up/down arrow key to highlight a drive, and then press <Space>
to select. A small triangle marks the selected drive. Press <Enter> after
completing your selection.
4-52
Copyright(C) 2003-08 Intel Corporation. All Rights Reserved.
Name:
RAID Level:
Disks:
Strip Size:
Capacity:
Enter a unique volume name that has no special characters and is
[TAB]-Next
Port Drive Model
0 XXXXXXXXXXXX
1 XXXXXXXXXXXX
2 XXXXXXXXXXXX
3 XXXXXXXXXXXX
Select 2 to 6 disks to use in creating the volume.
[↑↓]-Previous/Next [SPACE]-SelectsDisk
[ CREATE VOLUME MENU ]
Volume0
RAID0(Stripe)
Select Disks
128KB
XXX GB
Create Volume
[ HELP ]
16 characters or less.
[ESC]-Previous Menu
[ SELECT DISKS ]
Serial #
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
[ENTER]-Done
[Enter]-Select
Size Status
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
Chapter 4: Software support