Using A Two-Gang Junction Box - Panasonic WV-CW504S Installation Manual

Using a two-gang junction box

• When the camera is installed using the two-gang junction box, mount the camera attachment
(accessory) to the embedded box installed on the wall or ceiling as a first step.
Note:
• For wall mounting:
Installation shall be performed in such a manner that "MTOP" of the camera attachment faces
upward.
• For ceiling mounting:
The front side (model number indication face) of the camera shall be aligned in the direction of
the arrow in "<FRONT" on the camera attachment.
Using the mounting base WV-Q115
• When installing the camera with the mounting base WV-Q115, attach the mounting base to the
wall or ceiling in the first place. (+ next page.)
Mount the camera attachment (accessory) by using the screws supplied with mounting brack-
et. (+ next page.)
(Recommended tightening torque: 0.78 N·m {0.58 lbf·ft})
Note:
• When installing the camera on the wall or ceiling where cable holes are already provided, or
when installing the camera with exposed wiring, the mount bracket shall be used.
• The female screws for piping conform to ANSI NPSM (parallel pipe threads) 3/4".
The female screws for piping shall be removed with a hexagon wrench.
• To connect conduit from the top, refer to page 29.
16
[Mounting position on wall or ceiling]
46 mm {1-13/16"}
Camera attachment (accessory)
Two-gang junction box
83.5 mm {3-9/32"}