Connectors; Hardware Overview - Axis Q1604 User Manual

Network camera

Hide thumbs Also See for Q1604:

Table of Contents

AXIS Q1604 Network Camera

Power LED

Network LED

Control button

Iris connector

Power connector

I/O terminal connector

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).

Caution

Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded

network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar

shall be shielded (STP) and intended for their speciﬁc use. Make sure that the network switch is properly grounded. See

for regulatory requirements.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker

with a built-in ampliﬁer. A stereo connector must be used for the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For

instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup

> System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

Table of Contents