Troubleshooting - Clarity C110 User Manual

If the C110 is producing no sound:
1. Ensure that proper installation and setup procedures were followed
by reading the user guide carefully.
2. Check to see if all the equipment is turned on, including the
television, stereo or VCR.
3. Look over all the cord connections (power, audio from television
etc.), making sure none have become loose or disconnected.
4. Ensure that the line of sight from the C110 base to the headset
receiver is clear.
5. Check to see if the infrared sensor on the base is facing the headset
and make sure the headset sensor is facing the base.
6. If the microphone is being used, try either turning up the television
or repositioning the microphone.
7. The volume may be controlled by the television or the audio outputs
are turned off. Please refer to the television's manual or manufacturer
for more information.
If the sound produced by the C110 has static or is noisy:
1. If while in one mode (Stereo/Mono), static is experienced, switch
the base to the other mode.
2. Check the level of direct sunlight in the room. Too much direct
sunlight may cause interference.
3. Make sure the base is at the same height or above the level of the
headset when being worn.
4. Ensure the C110 Headset battery is fully charged.
Still Not Working?
If, after going through this checklist, the C110 is still not functioning
properly, call Clarity at 1-800-426-3738.
14

TROUBLESHOOTING