ClearSounds CSC48 Operating Manual page 13

store pairing information for up to eight (8) different devices
with Bluetooth wireless capability. Devices are stored in a
"Paired Device List" in the memory in a time sequence. When
an attempt to pair more than eight devices is made, the oldest
paired device is removed from the memory list. Any of the
eight paired devices can initiate a connection to the QUATTRO.
The QUATTRO will automatically initiate a connection (once
turned on) with the last device to which it was connected.
If you want to connect the QUATTRO to another device in
the paired device list, you must initiate the connection
from that device. When any of the eight devices initiates a
connection to your QUATTRO, that device then becomes the
"last connected" device.
ADJUSTING VOLUME
█
The receiving volume can be adjusted during a call or when
listening to other audio sources. The volume setting on the
cell phone or other device will add or remove amplification
from the overall system. If amplification is low, check the
volume level on both units. If there is distortion or other
interference, lower the volume on one or both of the units.
Too much amplification can cause distortion.
Adjustment while using the neckloop with t-coils
Use the volume control wheel located on the left side
of the unit (on your right when it is being worn). Slide
the wheel up to increase the volume and slide it down to
decrease the volume.
Adjustment while using a headset
Use the volume control buttons located on the left side
of the unit (on your right when it is being worn), which
is below the volume control wheel used for the neckloop.
Press the + button once to increase the volume and press
the – button once to decrease the volume. To continue
increasing or decreasing volume, pressthe + or – button
13 – ENGLISH