Connecting Usb Devices - Extreme Networks Summit WM3600 Installation Manual

Extreme networks - summit wireless lan controller

Hide thumbs Also See for Summit WM3600:

Table of Contents

Connecting USB Devices

The Summit WM3600 wireless LAN controller contains one USB port for connecting

USB flash storage devices to the controller. The controller can use the USB flash storage

device for file transfers and firmware updates. Follow the setup instructions below to

connect the devices to the controller and then access those devices through the Web UI

or Command Line Interface.

1 Connect the USB flash drive to the USB .

2 Wait a few seconds for the drive to be recognized by the controller.

3 Follow the instructions in the Summit WM3000 Series Controller System Reference Guide

or Summit WM3000 Series Controller CLI Reference Guide for more information on

accessing USB storage devices from the controller for file transfers or firmware

updates.

NOTE

The controller supports USB flash devices formatted with FAT or VFAT (FAT32) filesystems only. If

your flash storage device is formatted with another filesystem you will need to format the device

before it can be used in the system.

Summit WM3600 Wireless LAN Controller Installation Guide

Table of Contents