Dhcp Server Advanced Screen - ZyXEL Communications NBG4615 User Manual

Chapter 17 DHCP Server
Figure 102 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 65 Network > DHCP Server > General
LABEL
DHCP Server
IP Pool Starting
Address
Pool Size
Apply
Cancel

17.3 DHCP Server Advanced Screen

This screen allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC addresses. You can also use this screen to configure the DNS server information that the
NBG4615 v2 sends to the DHCP clients.
To change your NBG4615 v2's static DHCP settings, click Network > DHCP Server > Advanced.
The following screen displays.
162
DESCRIPTION
Select Enable to activate DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
individual clients (computers) to obtain TCP/IP configuration at startup from a server.
Enable the DHCP server unless your ISP instructs you to do otherwise. Select Disable
to stop the NBG4615 v2 acting as a DHCP server. When configured as a server, the
NBG4615 v2 provides TCP/IP configuration for the clients. If not, DHCP service is
disabled and you must have another DHCP server on your LAN, or else the computers
must be manually configured. When set as a server, fill in the following four fields.
This field specifies the first of the contiguous addresses in the IP address pool for LAN.
This field specifies the size, or count of the IP address pool for LAN.
Click Apply to save your changes back to the NBG4615 v2.
Click Cancel to begin configuring this screen afresh.
NBG4615 v2 User's Guide