Panasonic Lumix DMC-GF3 Basic Owner's Manual page 246

[INSERT SD CARD AGAIN]/[TRY ANOTHER CARD]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
> Insert a different card.
[CANNOT RECORD DUE TO INCOMPATIBLE FORMAT (NTSC/PAL) DATA ON THIS
CARD.]
> If you want to delete some pictures, format the card after saving necessary data on a PC
etc. (P68)
> Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with "Class 6" or higher when recording motion pictures
in [MOTION JPEG].
•
In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P68).
•
Depending on the type of the card, motion picture recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc.
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P68)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
•
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P172,
174)
Others
(P68)
- 190 -
If you execute
(P66)