Insignia NS-46E340A13 User Manual page 15

Insignia 46" LED TV
Using composite video (good)
To connect a cable or satellite box using
composite video:
1 Make sure that your TV's power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable or satellite
box.
3 Connect an AV cable (not provided) to the
COMPONENT/AV Y/VIDEO jack and L and R
audio jacks on the back of your TV and to the
composite video and audio out jacks on the
cable or satellite box.
Note
• The COMPONENT/AV Y/VIDEO, P
video jacks (used to connect a component
device) share the L and R audio jacks with the
COMPONENT/AV Y/VIDEO jack (used to
connect a composite device).
• When you connect the audio using the L and R
audio jacks, the audio output is analog.
Cables are often color-coded to match
color-coded jacks.
Note: The yellow video connector on the AV
cable connects to the green COMPONENT/AV
Y/VIDEO jack.
Back of TV
4 Plug your TV's power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the Setup Wizard on page 19.
, and P
B R
Cable or satellite box
Y / VIDEO
AV cable
www.insigniaproducts.com
Using coaxial (good)
To connect a cable or satellite box using coaxial:
1 Make sure that your TV's power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable or satellite
box.
3 Connect a coaxial cable (not provided) to the
ANT/CABLE jack on the back of your TV and to
the coaxial out jack on the cable or satellite box.
Back of TV
4 Plug your TV's power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the Setup Wizard on page 19.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
Cable or satellite box
Coaxial cable
Y / VIDEO
11