Main Memory - Intel BOXDX58SO Product Manual

Desktop board

Table of Contents

Intel Desktop Board DX58SO Product Guide

Main Memory

NOTE

To be fully compliant with all applicable Intel

board should be populated with DIMMs that support the Serial Presence Detect (SPD)

data structure. If your memory modules do not support SPD, you will see a

notification to this effect on the screen at power up. The BIOS will attempt to

configure the memory controller for normal operation.

The Desktop Board supports the following memory features:

• Four 240-pin Double Data Rate 3 (DDR3) SDRAM Dual Inline Memory Module

(DIMM) connectors with gold-plated contacts arranged in three channels

• 1333/1066/800 MHz DDR3 SDRAM interface

• Support for single-, dual-, and triple-channel memory interleaving

• Unbuffered, non-registered single or double-sided DIMMs with a voltage rating of

less than 1.6 V.

NOTE

Using a DIMM with a voltage rating higher than 1.6 V may damage the processor.

• Non-ECC DDR3 memory

• Serial Presence Detect (SPD) memory only

• Up to 16 GB maximum total system memory

NOTE

32-bit operating systems are limited to a maximum of 4 GB of memory. The

operating system report less than 4 GB because of the memory used by add-in

graphics cards.

Table of Contents

Dx58so