HP Color LaserJet 5500 Technical Reference Manual page 79

Variable
ORIENTATION
OUTBIN
OUTLINEPOINT-
SIZE
PAGEPROTECT
PALETTESOURCE
General PJL Environment Variables
Description
Page orientation.
Sets the default output bin. (For HP LaserJet
4Si, 4SiMx, 4000 series, 5Si, 5SiMx, 5Si
Mopier printers, the UPPER output bin is a
face-down, correct-order bin. The LOWER
output bin is a face-up reverse-order bin.)
Sets the point size used by PCL-XL to switch
from printing characters as bitmaps to
printing them as outlines.
Page protection configuration. The page
protection feature reserves a block of printer
memory to prevent printer overrun errors
(error 21) when formatting very dense or
complex images, especially HP-GL/2 images.
The variable can be set to any legal value at
any time, regardless of the current amount of
free memory or the currently set resolution.
When a job is sent, if there is not enough
memory to print correctly with the current
resolution and page protection configuration,
the system temporarily overrides the
resolution and/or page protect values to run
the job. In these cases, the job may be printed
at 300 dpi without page protection. When the
page protection status is changed, memory is
reconfigured and all downloaded fonts, PCL
macros, and PostScript dictionaries are lost
(however, no I/O data is lost). Refer to
"Commands that Affect Printer Memory" in
Appendix A.
Specifies how color settings are derived, either
from the device's control-panel settings or
through the software application.
Sample Value
Range
PORTRAIT,
LANDSCAPE
UPPER, LOWER,
OPTIONALOUT–
PUTBIN1, . . .
OPTIONALOUT–
PUTBIN62
0 to 999
OFF, LETTER,
LEGAL, A4,
AUTO, ON
DEVICE,
SOFTWARE
Environment Commands 6-17