Table of Contents
Advertisement
4. Remove the three Phillips PM2.0×4.0 screws 1 that secure the hard drive to the computer.
5. Use the Mylar tab 2 on the hard drive to slide the hard drive 3 to the left.
6. Remove the hard drive 4 from the hard drive bay.
7. If it is necessary to replace the hard drive bracket, follow these steps:
a. Remove the two Phillips PM3.0×3.0 screws 1 from each side of the hard drive.
b. Lift the bracket 2 straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Maintenance and Service Guide
Removal and replacement procedures
4–9
Advertisement
Table of Contents
