Installing A Second So-Dimm - HP t5740e - Thin Client Hardware Reference Manual

CAUTION:
cards. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object. When handling a memory module, be careful not to touch
any of the contacts. Doing so may damage the module.
To install the secondary flash memory module:
1. Locate the secondary flash memory module socket on the system board.
Figure 2-9
2. Insert the flash memory module into the socket on the system board.
NOTE:
memory module with the retention post on the system board.
3. Press the module connectors firmly into the flash memory module socket, making sure that the
retention post on the system board comes up through the hole in the module.
CAUTION:
on the same device.
If a secondary flash memory module is installed, do not operate the thin client in a horizontal
orientation. Install it in a vertical orientation, using either the stand (see
on page 5) or an HP Quick Release (see
mounting orientations and options).

Installing a Second SO-DIMM

Before beginning the replacement process, review
on page 11
WARNING!
removing the side access panel, ensure that the thin client is turned off and the power cord is
disconnected from the electrical outlet.
CAUTION:
cards. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object. When handling a memory module, be careful not to touch
any of the contacts. Doing so may damage the module.
ENWW
Static electricity can damage the electronic components of the computer or optional
Installing the Secondary Flash Memory Module
A flash memory module can be installed in only one way. Line up the hole in the flash
Do not install the secondary flash memory module and the PCIe/PCI Expansion Module
for procedures you should follow before and after installing or replacing hardware.
You must remove the left side panel to access the SO-DIMM compartment. Before
Static electricity can damage the electronic components of the computer or optional
Mounting the Thin Client on page 24
General Hardware Installation Sequence
Installing the Stand
for information about
Installing Thin Client Options
19