Figure 8. Mounting Configuration Dimensions For "Wc" And "Lc" Models - Seagate ST34520N - Medalist 4.55 GB Hard Drive Product Manual

Medalist Pro Product Manual, Rev. D
[3]
C
[1]
E
L
Pin 1
Connector Centerline
[7]
N X
M [5]
[2]
U [9]
J2
[9] T
H
S [11]
K
Figure 8. Mounting configuration dimensions for "WC" and "LC" models
F
A [3]
[5]
B
[7]
X
J
J6 LED
P [8]
R
G
D
Notes:
[1] Mounting holes three on each side, 6-32 UNC. Max screw length
into side of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0
in-lb (.675 NM) max with minimum thread engagement of 0.12 in.
(3.05 mm).
[2] Mounting holes four on bottom, 6-32 UNC. Max screw length into
bottom of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0
in-lb (.675 NM) max with minimum thread engagement of 0.12 in.
(3.05 mm).
[3] Interface connector is flush with the end of drive within
0.020 in. (.5 mm). The interface connector location may extend
beyond HDA dimension "A" by 0.020 in. (.5 mm).
[4] Connector J1 is centered (side to side) on drive within 0.020 in.
(.508 mm).
[5] Dimension "M" is from bottom rear drive mounting holes center(s)
to the face of the connector at the center of the drive.
[6] Dimensions "M" and "N" are unique requirements for SCA drives
only, required for conformance with latest SFF Spec #8337.
[7] Maximum connector non-perpendicularity to side planes pointed
to by X.
[8] Centerline of pad for Pin 1 of J6.
[9] Centerline of pad for Pin 1 of J2. Dimensions indicated are for
reference only.
[10] Dimensions to Pin 1 of each connector are nominal values.
[11] To pin ends on J6. Pin ends on J6 are nominally flush with end of
drive. Dimensions "K" and "S" may not be exactly the same.
Dimension Table
Inches
A 5.754
B 4.000
C 1.007
D 2.362
E 1.120
F 4.000
G .250
H 1.750
J 3.750
K TBD
L 0.181
[6] M 1.62
N .015
[7]
P .405
R 2.265
S 2.350
T .061
U 0.26
Millimeters
.026 146.15 .66
.015 101.6 .38
.013 25.6 .33
.010 60.00 .25
.020 28.45 .51
.010 101.60 .25
+ .010 6.35 + .25
– .005 – .12
.010 44.45 .25
.010 95.25 .25
TBD TBD TBD
+ .015 4.597 + .38
– .010 – .25
.02 41.15 .50
.38
10.29
52.53
59.69
[10] [10]
1.55
6.60
29