Toshiba Satellite A300 series Maintenance Manual page 163

Replacement Procedures
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-19 to
4-21).
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.0×8.0
• M2.5×6.5
4. Disassemble the cable from cable-drain while taking the antenna cable to PCB hole.
Satellite A300 Maintenance Manual(960-Q08)
FLAT BIND screw Back
FLAT BIND screw Back
x9
x9
4-32