HP Rp3000 - Point of Sale System Troubleshooting Manual page 54

Table A-1 Numeric Codes and Text Messages (continued)
Control panel message
1151-Serial Port A Address Conflict Detected Both external and internal serial ports are
1152-Serial Port B Address Conflict Detected Both external and internal serial ports are
1155-Serial Port Address Conflict Detected
1201-System Audio Address Conflict
Detected
1202-MIDI Port Address Conflict Detected
1203-Game Port Address Conflict Detected
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
1797-SATA Drivelock is not supported in
RAID mode.
48 Appendix A POST Error Messages
Description
assigned to COM1.
assigned to COM2.
Both external and internal serial ports are
assigned to same IRQ.
Device IRQ address conflicts with another
device.
Device IRQ address conflicts with another
device.
Device IRQ address conflicts with another
device.
Hard drive is about to fail. (Some hard drives
have a hard drive firmware patch that will fix
an erroneous error message.)
One or more SATA devices are improperly
attached.
Drivelock is enabled on one or more SATA
hard drives, and they cannot be accessed
while the system is configured for RAID
mode.
Recommended action
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 53.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 53.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 53.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
1. Determine if hard drive is giving correct
error message. Enter Computer Setup
and run the Drive Protection System test
under Storage > DPS Self-test.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard
drive.
For a hard drive, use SATA 0. For an optical
drive, use SATA 1.
Either remove the Drivelocked SATA device
or disable the Drivelock feature. To disable
the Drivelock feature, enter Computer Setup,
change Storage > Storage Options > SATA
Emulation to IDE, and select File > Save
Changes and Exit. Reenter Computer Setup
and select Security > Drivelock. For each
listed Drivelock-capable SATA device,
ensure Drivelock is Disabled. Lastly, change
Storage > Storage Options > SATA
ENWW