HP Rp3000 - Point of Sale System Troubleshooting Manual page 53

Troubleshooting guide
Hide thumbs Also See for Rp3000 - Point of Sale System:
Table of Contents

Advertisement

Table A-1
Numeric Codes and Text Messages (continued)
Control panel message
303-Keyboard Controller Error
304-Keyboard or System Unit Error
404-Parallel Port Address Conflict Detected
410-Audio Interrupt Conflict
411-Network Interface Card Interrupt Conflict IRQ address conflicts with another device.
501-Display Adapter Failure
510-Flash Screen Image Corrupted
512-Chassis Fan not Detected
514-Chassis Fan not Detected
610-External Storage Device Failure
660-Display cache is detected unreliable
ENWW
Description
I/O board keyboard controller.
Keyboard failure.
Both external and internal ports are assigned
to parallel port X.
IRQ address conflicts with another device.
Graphics display controller.
Flash Screen image has errors.
Chassis fan is not connected or may have
malfunctioned.
Chassis fan is not connected or may have
malfunctioned.
External tape drive not connected.
Integrated graphics controller display cache
is not working properly and will be disabled.
Recommended action
1.
Reconnect keyboard with computer
turned off.
2.
Replace the system board.
1.
Reconnect the keyboard with computer
turned off.
2.
Ensure that none of the keys are
depressed.
3.
Replace the keyboard.
4.
Replace the system board.
1.
Remove any parallel port expansion
cards.
2.
Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page
3.
Reconfigure card resources and/or run
Computer Setup.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
1.
Reseat the graphics card (if applicable).
2.
Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page
3.
Verify monitor is attached and turned
on.
4.
Replace the graphics card (if possible).
Reflash the system ROM with the latest BIOS
image.
1.
Reseat chassis fan.
2.
Reseat fan cable.
3.
Replace chassis fan.
1.
Reseat chassis fan.
2.
Reseat fan cable.
3.
Replace chassis fan.
Reinstall tape drive or press
system to reconfigure without the drive.
Replace system board if minimal graphics
degrading is an issue.
POST Numeric Codes and Text Messages
53.)
53.)
F1
and allow
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents