HP Rp2430 - Server - 650 MHz User Manual page 34

A-Class Server Installation
Cabinet-Mounted A-Class Server System Unpack and Install
The cabinet/server system assembly is now ready for the power up process. Refer to the
section titled, A-Class Server Power Up and Boot Procedures.
PowerTrust UPS Option
Unpack the PowerTrust UPS and read all the installation information in the PowerTrust
System Guide, part number 5961-8383. Once all the procedures listed in the UPS guide
are complete, perform the following steps to complete the UPS installation with the
cabinet.
1. Position the UPS next to the cabinet on the floor.
2. Remove the jumper cord from the SPU to the PDU inside the cabinet.
3. Install one of the convenience cords (output cord) that came with the UPS into the
4. Place the other end of that cord into one of the Output outlets in the back of the UPS.
5. The other convenience cord is connected between the UPS and the system console.
6. Locate the appropriate input line cord for the UPS in the supplemental package
7. Plug the UPS into the appropriate wall outlet.
8. The system should now be ready for power up. Refer to the section titled, A-Class
Repackaging the Cabinet for Shipment
Use the original packing material to repackage the cabinet for shipment. If the packing
material is not available, contact your local Hewlett-Packard Sales and Support Office
regarding shipment.
Before shipment, place a tag on the container (or equipment) to identify the owner and
the service to be performed. Include the equipment model number and the full serial
number, if applicable. The label showing the model number and the full serial number is
located on the outside of the rear door.
Due to the weight of a fully loaded cabinet, it will require two people to push the cabinet
up the ramp onto the pallet.
WARNING
Repackaging a loaded cabinet may be hazardous because a fully configured 2.0
meter cabinet can weigh up to 362.8 kg (800 lbs). Always use two people when
moving the cabinet and when positioning the cabinet on the pallet. Check the
condition of the loading/unloading ramp before use. If the ramp appears
damaged, DO NOT attempt to push a loaded cabinet up the ramp onto the
34
AC receptacle in the back of the SPU.
shipped with the UPS.
Server Power Up and Boot Procedures.
Chapter 2