Changing Parameter Settings - IBM NetVista Hardware Maintenance Manual

The following table lists specific keys on the keyboard
that will help you move through the Configuration/
Setup Utility Menus:
Keys
Down- or up-
arrow key
Left- or right-
arrow key
F1
Esc
Enter
F10
F7
F5

Changing Parameter Settings

In the Configuration/Setup Utility Menus, the
configuration information that you can change is
enclosed in brackets like these: [ ]. You cannot
change any information that is not enclosed in
brackets. Use the up- or down- arrow keys to
highlight options then press Enter to display a menu.
When changing the setting of a particular parameter,
highlight the setting then use the left- or right- arrow
key to change the setting. Refer to the Configuration/
Setup Utility help for details on the configurable
parameters in each menu.
Use these arrow keys to highlight
an option on the menu. (Press the
Enter key to choose the option.)
Use these arrow keys to make a
selection and change an option's
setting. On some menus, you can
use these keys to move from one
field to another.
Press this key if you want help for a
selected menu option.
After viewing or making changes to
the settings on a menu, press this
key to exit the menu.
Press this key to choose a
highlighted option from a menu
Press this key if you want to save
the current settings for a line
Press this key if you want to load
the factory default settings from the
selected brackets.
Press this key if you want to restore
item previous setting
General Information 15
Function