Replacing The External Speaker; Completing The Installation - Lenovo K100 Hardware Replacement Manual

6. Refer to the "Completing the installation."

Replacing the External speaker

1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down the computer, and turn off all
attached devices.
2. Unplug all power cords from electrical outlets.
3. Locate the Speaker. Refer to "Locating connectors on the rear of the computer" and "Locating connectors
on the front of the computer". Your speaker might be connected to the Audio connector
connector at either the front or rear of the computer. Locate the connector for the speaker.
4. Disconnect the failing speaker cable from the computer and connect the new speaker cable to the same
connector.
5. Refer to the "Completing the parts replacement".

Completing the installation

After replacing the parts, you need to close the computer cover and reconnect cables, including telephone
lines and power cords. Also, depending on the part that was replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to "Starting the Setup Utility" in the User Guide or in the
Hardware Maintenance Manual.
To complete the part installation:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. Refer to "Locating components" for the location of the various components.
2. Make sure that the cables are routed correctly before replacing the computer cover.
3. Position the computer cover on the chassis so that the rail guides on the bottom of the computer cover
engage the rails. Then, push the computer cover closed until it snaps into position.
24
Hardware Replacement Guide
31031416 Greenland HRG_EN.indd 24
to a Audio
2007.8.20 4:05:59 PM