Cleaning the cooling module
This section explains how to clean the cooling module.
If you use the computer for a long period, the inside of the computer may
become hot. Always allow the computer to cool to room temperature
before you clean the cooling module.
To clean the cooling module, follow the steps detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel and turn the computer upside down.
4. Remove the battery pack (refer to the
section in Chapter 6,
5. Using a thin-tipped tool, push on the hole in the edge of the Cooling
module cover and slide it in the direction of the arrow to remove.
2
User's Manual
Turning off the power
Power and Power-Up
1. Hole
2. Cooling module cover
Figure F-1 Removing the cooling module cover
TECRA A11/S11, Satellite Pro S500
section in Chapter 1,
Replacing the battery pack
Modes, if required).
Getting
Started, if
1
F-3