Adaptec Slimscsi 1480A Pc Card Causes System Hang; Wake-On-Ring (Wor) Might Not Work When Using Some Pc Card Modems; Some Pc Cards Might Not Be Detected After Resuming From Standby Mode; Ibm Token Ring Pc Card Driver Is Not Included In Windows Me - Lenovo ThinkPad i Series 1200 Installation Manual

the first time, yellow "!" will appear on PCMCIA Card Services in the
Device Manager as code 1. This does not cause any functionality loss.
Cause: By Windows Me design
Continue to use the PC Card. Once the system reboots, the yellow "!"
Resolution:
disappears.
3.2

Adaptec SlimSCSI 1480A PC Card causes system hang

ThinkPad models 390, 600X
Models:
System hangs when Adaptec Slim SCSI 1480A in cold or hot inserted.
Issue:
SlimSCSI 1480A is not supported.
Resolution:
3.3

Wake-On-Ring (WOR) might not work when using some PC Card Modems

All ThinkPad models
Models:
Issue: When using some PC Card modems under Windows Me, you may
notice a power management setting for the device listed in Device
Manager. While Wake-On-Ring is enabled in the Power Manager,
WOR feature may not function properly.
OS does not support wakeup capability from Standby mode for an
Cause:
incoming call. This is a current limitation for this release of Windows
Me. Only some CardBus modem cards support this function.
Do not use the WOR function with PC Card modems.
Resolution:
3.4

Some PC cards might not be detected after resuming from Standby mode.

Models: ThinkPad 240X
Some PC cards may not be detected when the system resumes from
Issue:
standby.
Cause: This is caused by PC Card device driver.
Install any PC cards prior to putting the system into Standby or Hot
Resolution:
unplug and then plug PC Card.
3.5

IBM Token Ring PC Card driver is not included in Windows Me.

All ThinkPad models
Models:
Issue: IBM Token Ring PC Card driver is not included in Windows Me.
Token Ring PC Card driver and the installation guide can be obtained
Resolution:
at: http://www.networking.ibm.com.
3.6

ATA PC Card does not work.

Models: ThinkPad 600X
ATA cards will have a resource conflict if "Warm swap device" for
Issue:
the IBM ThinkPad Ultra Bay is enabled
Hardware Limitation
Cause:
Warm Swap for the IBM ThinkPad Device Bay must be disabled
Resolution:
1. Click Start → Settings → Control Panel
2. Double-click System icon
3. Double-Click ThinkPad Configuration