Port Mapping Of Server Blade Fc Hba Mezzanine Cards - HP BL685c - ProLiant - 4 GB RAM Connectivity Manual

HP 4Gb Pass-Thru Module for the HP c-Class BladeSystem
The HP 4Gb Pass-Thru Module provides transparent, 1:1 port connectivity (16 internal/16 external)
between HBA mezzanine ports and external SAN devices or switches. The module, which has 16
ports with short-wave 4-Gb SFP transceivers, provides a solution for connecting c-Class FC HBAs to a
local SAN. It is suitable for installations where the SAN is in close proximity and the amount of
cabling is not a major concern.
Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem
The Cisco MDS 9124e Fabric Switch installs directly into c-Class enclosures. Integrating the switch
within the enclosure simplifies SAN network deployment by reducing the costs of cabling, SFP
transceivers, and installation time. Cost is further reduced by sharing intelligent power and cooling
resources provided by the enclosure. The Cisco 4-Gb SAN Switch includes Cisco Fabric Manager for
integrated, comprehensive SAN management including fabric configuration, verification, and
monitoring. Also included is a broad range of integration tools, including the Cisco MDS 9000 family
Command Line Interface (CLI) and industry-standard third-party SNMP and SMI-S application
programming interfaces (APIs). This switch is available in 12-port and 24-port models that include two
and four short-wave 4-Gb SFP transceivers respectively. A 12-port upgrade license is available for the
12-port model. The Cisco switch provides the following additional capabilities:
• Traffic management – Simplified deployment with virtual output queuing and Fastest Shortest Path
First (FSPF) technology optimizes the fabric performance.
• Virtual SAN (VSAN) support – Up to 16 VSANs per switch can be managed as independent
fabrics for more efficiency and lower cost through shared use, and for increased security through
isolation of devices on the same physical SAN.

Port mapping of server blade FC HBA mezzanine cards

The mapping of server blade communications ports is hard-wired into the signal midplane of c-Class
enclosures. All c-Class server blades include two or four embedded network interface controllers
(NICs) connected by the midplane to interconnect bays 1 and 2, which are dedicated for Ethernet
modules. The fabric designation of interconnect bays 3 through 8 is dependent upon the optional
mezzanine cards installed on the server blades.
Figure 5 shows the mapping of FC options for the HP BladeSystem c7000 enclosure.
NOTE:
Mezzanine cards for c-Class server blades are defined as being
1x, 2x, or 4x port types, with nx referring to the number of
interconnect lines per port provided by the controller. FC HBA
mezzanine cards are 1x port type.
7