Asus P4B-LS User Manual page 43

6. USB device wake-up (USBPWR, FUSB)
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S3 sleep mode (no power to CPU, DRAM in slow refresh, power
supply in reduced power mode). Both jumpers are set to pins 2-3 (+5V)
by default because not all computers have the appropriate power
supply to support this feature.
The USBPWR jumper is for the rear USB ports. The FUSB jumper is
for the internal USB header that you can connect to the front USB
ports.
1. This feature requires a power supply that can provide at least 1A
on the +5VSB lead when these jumpers are set to +5VSB.
Otherwise, the system does not power up.
2. The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep
mode.
P4B-LS USB Device Wake Up
Figure 2-27 USB Device Wake-up Settings
ASUS P4B-LS motherboard user guide
®
P4B-LS
USBPWR
1 2
2 3
+5VSB +5V
(Default)
FUSB
1 2
2 3
+5VSB +5V
(Default)
2-21