Uefi Setup Utility; Introduction; Uefi Menu Bar - ASROCK 970 Pro3 R2.0 User Manual

3. UEFI SETUP UTILITY

3.1 Introduction

This section explains how to use the UEFI SETUP UTILITY to configure your sys-
tem. The SPI Memory on the motherboard stores the UEFI SETUP UTILITY. You
may run the UEFI SETUP UTILITY when you start up the computer. Please press
<F2> or <Del> during the Power-On-Self-Test (POST) to enter the UEFI SETUP
UTILITY, otherwise, POST will continue with its test routines.
If you wish to enter the UEFI SETUP UTILITY after POST, restart the system by
pressing <Ctl> + <Alt> + <Delete>, or by pressing the reset button on the system
chassis. You may also restart by turning the system off and then back on.
Because the UEFI software is constantly being updated, the following
UEFI setup screens and descriptions are for reference purpose only,
and they may not exactly match what you see on your screen.

3.1.1 UEFI Menu Bar

The top of the screen has a menu bar with the following selections:
Main
OC Tweaker
Advanced
H/W Monitor
Boot
Security
Exit
Use < > key or <
bar, and then press <Enter> to get into the sub screen.
To set up the system time/date information
To set up overclocking features
To set up the advanced UEFI features
To display current hardware status
To set up the default system device to locate and load the
Operating System
To set up the security features
To exit the current screen or the UEFI SETUP UTILITY
> key to choose among the selections on the menu
41